Project Description



Product Overview

Improve Officer Safety and Efficiency
Officers are constantly occupied with technology and other distractions that require a shift in concentration and a refocus of the eyes and hands. bluePRINT allows officers to stay focused on the task at hand while keeping their eyes on the road and hands on the wheel. Light and siren configurations are pre-programmed and prioritized to respond to emergency situations without the officer having to hastily determine which buttons and switches to activate while driving.

Eliminate Point-to-Point Wiring
Each of these modules communicates over a serial data bus (multiplex). The Central Controller, the Remote Nodes, the Input Node, and the 200R Sirens all share a single wire bus that can run the length of the vehicle. This eliminates the need for point-to-point wiring between lighting and siren components. Separate LIN data bus connections are provided for plug-and-play compatibility with existing SoundOff Signal Exterior Lightbars, nForce Interior Lightbars/Traffic Arrows, and Siren components.

Improve System Reliability and Convenience
Current switching within the Central Controller and Remote Nodes uses Solid State Transistors to eliminate mechanical switching. Relays and other electro-mechanical components are often the most frequent failure within a switching system. Most are incapable of detecting faults and can be damaged by wiring faults such as an over-current. Solid State switching offers the advantage of no moving parts, no arc bridging, and self-diagnostic capabilities.

Product Numbers

ENGSA03021nERGY® bluePRINT® 100 Watt Compact Remote Siren Amplifier – 10-30v for use with single 100w or dual 58w speaker(s)
ENGSA07141nERGY® bluePRINT® 400 Series Remote  Siren/Switch Module, 10-16v – 100w one speaker, with Nine 10-Amp & Three 20-Amp Relay Outputs
ENGSA07152nERGY® bluePRINT® 400 Series Remote  Siren/Switch Module, 10-16v – 200w two speakers, with Nine 10-Amp & Three 20-Amp Relay Outputs
ENGCC01241nERGY® bluePRINT® Central Controller – Communication Hub for use within the EV Control System – 1 Active High Ignition Input, 24 Outputs (100 Amps max)
ENGCP18001nERGY® bluePRINT® Remote Control Panel – 15 Programmable Buttons w/ 3 Position Slide Switch
ENGND20001nERGY® bluePRINT® Input Node – Provides 20 inputs for connection to vehicle devices, 13 Active High/Low Inputs & 7 Active High Inputs
ENGND04101nERGY® bluePRINT® Remote Node, 4 Active High/Low Inputs, 10 Outputs  (50 Amps max)

Technical Specifications


10-16 Vdc (Negative Ground)


Up to 70 programmable outputs

Up to 40 inputs

Software Requirements
PC or Tablet (used only for initial programming and diagnostics):
•Windows Vista® SP1 or later
•Pentium 1GHz or higher
•Minimum 512MB RAM
•Minimum disk space 1GB
•.NET 4.0 Library (will be prompted to download if not
already installed, additional 2GB needed)
•USB 1.1 or higher, cable with Type B plug

Back to SoundOff Signal’s products